AIS Router AI2524 Bedienungsanleitung PDF herunterladen (Seite 393)

100

101

Chapter 16: Basic Configuration

August 1997 Page 16-17

2524UM

Configuring the

Fractional T1/T1

DSU/CSU WAN

Module

This section describes how to configure the fractional Tl/T1 DSU/

CSU WAN module is configured for Extended Superframe Format

(ESF) signal format, bipolar zero substitution (B8ZS), and full band-

width as the factory default. Depending on networking environment,

you might need to change these settings.

Take these steps to configure the fractional Tl/T1 DSU/CSU WAN

module for a typical leased-line connection, substituting the correct

addresses and host names as appropriate for your network:

1. Enter enable mode:

Router> enable

password: enablepassword

2. Enter configuration mode:

Router# config term

Router(config)#

3. Assign an IP address to the serial port on the module:

Router(config)# interface serial port_number

Router(config-if)# ip address ipaddress suLnetmask

Router(config-if)# no keepalive

4. Enter the framing type and line code type, substituting

framing_type with

(Superframe) o

esf

(Extended Super

frame) and

linecode_type with

ami

(alternate mark inversion) o

b8zs

(bipolar eight zero substitution):

Router(config-if)# service-module tl framing

framing_type

Router(config-if)# service-module tl linecode linecode type

5. If you are using fractional T1 service, enter the time slot range and

speed. In this example, the time slot range is from 1 to 20 and the

speed is 64-kbps:

Router(config.f)#

service-module tl timeslots 1-20 speed 64

1 2 ... 388 389 390 391 392 393 394 395 396 397 398 ... 417 418

Kommentare zu diesen Handbüchern

Keine Kommentare

AIS Router AI2524 Bedienungsanleitung Seite 393

Kommentare zu diesen Handbüchern